Run actions after component success or failure

In this section you will learn about Success/Error Actions

Use success and error actions in a component's Actions configuration to respond after its base action completes. For example, navigate after a form submission or show a failure response.

These are component callbacks. They do not define a global error handler for every workflow step.

Configure a callback

1. Select the button or component.

2. Open its Actions tab.

3. Select Success Action or the error action.

4. Choose the response and configure its inputs.

Multiple callback operations run in parallel rather than as a guaranteed sequence. If a notification depends on an earlier update's result, put the dependent operations in an explicitly ordered workflow.

Navigate after success

Choose Navigate to Page as the success action and select the destination page.

Test both a successful submission and a failed submission. The app should navigate only after the intended successful action.

Send an email after success

Choose Run Operation → App Built-ins → Send Email and configure the recipient and message.

Test with an address you control. Use dynamic values from the action's available context rather than a fixed recipient intended only for setup.

Verify failure behavior

Cause a controlled failure using fictional input. Confirm that the error response appears and that success-only effects do not occur. Check whether the base action changed any data before retrying.

See failure handling and running a workflow from a callback.